How to use it

  1. Enter how many disks you have and the size of each one.
  2. Pick the RAID level, or Synology SHR if you run a Synology NAS.
  3. Read off the usable capacity, how much is lost to redundancy, and how many disks the array survives losing.

Which RAID level

  • RAID 0: all capacity, no redundancy. One failed disk loses everything. Fine for scratch data, not for anything you care about.
  • RAID 1: a straight mirror of two disks. Simple and safe, but you only keep half the space.
  • RAID 5: one disk of parity. Good balance for three or more disks, but a second failure during a rebuild loses the array.
  • RAID 6: two disks of parity. The safer choice for large disks, where rebuilds take a long time.
  • RAID 10: mirrored pairs that are then striped. Fast and resilient, but you lose half the space.
  • Synology SHR: Synology’s own layout. It behaves like RAID 5 (or RAID 6 with the two-disk option) but uses more of the space when your disks are different sizes.

Why the numbers look smaller than the label

Disk makers count a terabyte as 1,000,000,000,000 bytes, but most operating systems count in binary, where a tebibyte is 1,099,511,627,776 bytes. So a 4 TB disk shows as about 3.64 TiB before any RAID overhead. The calculator shows both.